 |
 |
 |
|
Water Power Tublift
Hoyer lifting solutions designed for use in the home.
Lightweight and durable, the 040-0121AC Tublift weighs only 19 pounds, yet is
capable if lifting up to 200 pounds on water pressure as low as 20 PSI. The
Tublift uses standard household water pressure to slowly and steadily lift the
patient up to 24 inches and lower to within five inches of the tub bottom.
Easy and safe operation. Connects to tubs the water spigot and runs efficiently on water pressure. Swivel seat makes access easy.
The Guardian Tublift comes complete with both a shower connection and a
spout connection. If the bath has a shower, you MUST use a shower
connection. If there is no shower, use the spout connection.
Connecting to the tub spout:
Remove the existing spout. Install the provided spout connection. The Tublift supply hose will connect to the nipple on the underside of the spout.
Connecting to the shower:
Remove the existing shower head and install provided connection (E) onto the shower pipe. Screw the shower head back on to the end of the connection. The Tublift supply hose will connect to the side of the connection.
Tublift Operation:
(It is recommended to operate the Tublift through a few up and down cycles to “Bleed” any air from the cylinder.)
- Turn on the water.
- If Tub lift is connected to the SPOUT: Pull up on the knob on top of the spout and go to instruction 4.
- If Tub lift is connected to the SHOWER: Make sure the diverter is turned toward the supply hose to the Tub lift. Turn on the shower as you would before installation and go to instruction 4.
- Turn the valve on the Tub lift to the “UP” position and the seat will rise.
- Turn the control valve to the “DOWN” position and the seat will slowly descend. You may control the rate of descent with small valve adjustments.
|
|
|
|
|
|
 |
|
 |
|
Features:
- Lightweight and durable
- Weighs only 19 pounds
- Water pressure operated
- 1-Year Warranty
- 200 lbs wt capacity
 Hoyer Tub Lift User Manual
|
|
|
 |
|
 |
|
|
|
BLOGSPOT 
